This is found in our user manual on page 18. THIS STEP IS ONLY A FUNCTION OF THE 3G M.I.N.E.™ CAMERA. THE 3G I.C.E.™ CAMERA DOES NOT UTILIZE AN INTERNAL TRANSMITTER.
The 3G M.I.N.E. Camera has an internal transmitter on the circuit board and must be located within 50 meters of the M.I.N.E.™ Gate to operate correctly. Users must manually calibrate the camera transmitter signal to each control box receiver the first time they are paired together. One camera will operate multiple control box receivers to trigger multiple gates simultaneously at a trap enclosure.
- Move camera selector switch from OFF to SETUP.
- Open control box housing and press the receiver button. The receiver red light will only emit for 10 to 15 seconds.
- Press the camera (A) left arrow and release then press the camera (B) right arrow and release to send a manual RF signal to the control box (You will see RF Trigger in the bottom of the screen). The receiver light should flash three times and shut off if performed correctly. Conduct a test by repeating this step, the latch will activate.
Repeat these steps on other control box receivers if multiple gates are used at the trap enclosure. Move camera selector switch from SETUP to ON and send SMS text command *777# to test transmitter and receiver calibration and gate operation.
To time or re-sync your onsite remote. In the control box, press and release the button, the red light will come on. Press and hold for 2 seconds then release the button on your remote, the light will come on, simultaneously, the red light inside the control box will blink 3 times and go out. Conduct a test by pressing the button again, the latch will activate. If it does not work the first time, try again.
← Support Center